Horizontal Rail Installation Guide

What's in the Box

Follow the steps below to install your Horizontal Rail. For a complete walkthrough, watch the installation video above.

Measure 18" from one end of each dowel and make a small mark. Slide the center wall mount onto both dowels so it lines up with the marks.

Positioning the center mount first ensures it sits perfectly in the middle of the rail.

Slide the planter attachments onto the dowels, positioning one on each side of the center wall mount.

The attachments can be repositioned later, so they don't need to be perfectly placed before mounting the rail.

Slide the left and right wall mounts onto the ends of the dowels.

Insert the included keyhole markers into the keyhole slots on all three wall mounts.

Hold the assembled rail against the wall in the desired location and use a level to make sure it is straight.

Firmly press the wall mounts against the wall. The keyhole markers will leave small indents showing exactly where to drill.

Remove the rail and drill a hole at each marked location using a 1/4" drill bit.

Insert the included wall anchors into the drilled holes, then drive in the included screws.

Leave each screw head slightly proud of the wall. Use the included depth gauge to determine the correct screw depth.

Align the keyhole slots on all three wall mounts with the screw heads and slide the rail downward until it locks into place.

If the fit is too loose or too tight, remove the rail and make a small adjustment to the screw depth.

Slide each planter onto a planter attachment until fully seated.

Insert the removable inner pots and add your favorite plants.